I'm trying to figure out how to trigger a routine when a especific pin changes from digital low to high.
I can eventually create a jump to a short check on that pin and then return to...
I disagree. If the compiler adds a CLRWDT in between every single instruction then there's no point in having it in the first place.
It's not going to detect a "fast loop" you make in your code.
PBP does handle it in, dare I say, >99% of cases. Here's one, fairly unrealstic case, where it doesn't.
I don't think PBP analyses the code in the details and determine exactly where to insert...
Published on - 27th May 2010 02:01
Number of Views: 9778
This is an effort to help users understand how the I2C command works by comparing it with SHIFTIN/SHIFTOUT. A serial EEPROM, 24FC1025 will be used in the example.
My TMR1_INT Blinky is not blinking
16F18877
Demon Today, 02:40Mostly taken from:
https://dt.picbasic.co.uk/INT14/TMR1INT
#CONFIG
__config _CONFIG1, _FEXTOSC_OFF & _RSTOSC_HFINT32 & _CLKOUTEN_OFF & _CSWEN_OFF & _FCMEN_ON
__config...